Dialogic TX4000 PCI SS7 Installation Manual download pdf (Page 21)

Configuring the TX 4000 board

Using the configuration utility

After you install the TX 4000 board and the NaturalAccess Signaling Software, you

must assign a CP number to each TX 4000 board. Verify that you have completed

the steps described in the installation summary on page 16 before you proceed to

assigning a CP number on page 22.

To assign a CP number, you will use the txcpcfg utility. Depending on the operating

environment, the txcpcfg utility is located in one of the following directories:

Operating system Directory

Windows Program Files\Dialogic\tx\bin\

UNIX /opt/dialogic/tx/bin/

txcpcfg enables you to perform the following types of changes to the configuration:

• Assign a CP number

• Add a board

• Change a CP number

• Move a board

• Remove a board

• Save configuration changes

For more information about txcpcfg, refer to the Dialogic® TX Series SS7 Boards TX

Utilities Manual.

Dialogic Corporation 21

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 47 48

No comments

Dialogic TX4000 PCI SS7 Installation Manual Page 21